GM Closed Element CLT/IAT Sensor with Connector

What size hole do I need to drill to install this sensor?

• The hole should be tapped for 3/8″ NPT.  Your tap will come with instructions for the preferred drill size, which is likely to be 9/16″.

What is its resistance vs temperature curve?

• If you are connecting this to a device that supports 3 point calibration (all MegaSquirt units do), use these numbers if your device does not have a standard GM temperature sensor calibration curve.
  • 7000 ohms at 48 degrees F
  • 1930 ohms at 87 degrees F
  • 560 ohms at 146 degrees F

I am using it with a device that requires a voltage vs temperature curve. What data do I enter?

• This sensor outputs resistance, not voltage. You will need additional, external circuitry to convert its output into a voltage, and the voltage will depend on the design of the external circuit.

Can I buy the connector separately?

• We currently buy the sensor and connector as a single item and do not stock the connector on its own.