$23.99
-
DB15 pigtail harness. Used for the extra I/O capabilities of the MSPNP Gen2 with V1.2 PCB (the version with the red main board).
You must be logged in to post a comment.
There are no questions yet, be the first to ask something for this product.
This electronic boost control solenoid can be used with the MS3-Pro/MSPNP2 or with other electronic boost controllers to control boost by adjusting the pressure to a turbo wastegate. The MS3-Pro, MS3-Pro Plug and Play, & MSPNP2 can drive this direct...
Add to cart
This tool makes de-pinning Weather Pack connectors a simple snap or poke. Just pop the seal retainer off, poke the tool in from the terminal side, slipping the tool over the terminal all the way in to release the latch, and pull the wire out from the...
Add to cart
TPS-3 Connector (Uncrimped) GM Style 3-pin TPS Connector complete with: the 3-pin connector three pins plus an extra fourth pin (just in case)
Add to cart
Black Ford TFI module connector. Note that this is not keyed the same way as the gray connector; the notch on the right side of this connector in the photo is on the left side of the gray connector. Check your module before ordering.
Add to cart
Three pin, GM WeatherPack style, inline throttle position sensor. Fits the TPS on many GM TPI installations, Holley Stealth Ram and Pro-Jection, and Rochester feedback carburetors. Note the keying, shown in the product gallery zoom.
Read more
Many older tachometers trigger off the negative terminal of the ignition coil. Often, these use a filtering circuit which will not trigger when given a 0 to 12 volt square wave signal, such as the tach output signal from an ECU or ignition box. If you h...
Add to cart
Reviews
There are no reviews yet.