$23.99
-
DB15 pigtail harness. Used for the extra I/O capabilities of the MSPNP Gen2 with V1.2 PCB (the version with the red main board).
You must be logged in to post a comment.
There are no questions yet, be the first to ask something for this product.
Weatherpack style connector for GM boost control solenoid. This connector comes with crimp-on pins to keep the number of splices in your wiring harness to a minimum. Note: This connector is not needed for our newer style (12/2008 and newer) non-GM EBC ...
Add to cart
Three pin, GM WeatherPack style, inline throttle position sensor. Fits the TPS on many GM TPI installations, Holley Stealth Ram and Pro-Jection, and Rochester feedback carburetors. Note the keying, shown in the product gallery zoom.
Read more
This 3 wire pigtail connector fits a number of GM applications, including certain camshaft position sensors, fan switch sensors, and oil pressure sensors. Please check against your existing socket before ordering.
Add to cart
MegaSquirtPNP and DIYPNP IAT Sensor Kit - Steel Bung This is a simple kit to make it easier for you when removing your AFM/MAF when using a MegaSquirtPNP or DIYPNP. In many cases, the air temperature sensor is built into the MAF, so removing it will re...
Add to cart
This electronic boost control solenoid can be used with the MS3-Pro/MSPNP2 or with other electronic boost controllers to control boost by adjusting the pressure to a turbo wastegate. The MS3-Pro, MS3-Pro Plug and Play, & MSPNP2 can drive this direct...
Add to cart
Many older tachometers trigger off the negative terminal of the ignition coil. Often, these use a filtering circuit which will not trigger when given a 0 to 12 volt square wave signal, such as the tach output signal from an ECU or ignition box. If you h...
Add to cart
Reviews
There are no reviews yet.