$23.99
-
DB15 pigtail harness. Used for the extra I/O capabilities of the MSPNP Gen2 with V1.2 PCB (the version with the red main board).
You must be logged in to post a comment.
There are no questions yet, be the first to ask something for this product.
MegaSquirtPNP and DIYPNP IAT Sensor Kit - Steel Bung This is a simple kit to make it easier for you when removing your AFM/MAF when using a MegaSquirtPNP or DIYPNP. In many cases, the air temperature sensor is built into the MAF, so removing it will re...
Add to cart
MegaSquirtPNP and DIYPNP IAT Sensor Kit - Steel Bung This is a simple kit to make it easier for you when removing your AFM/MAF when using a MegaSquirtPNP or DIYPNP. In many cases, the air temperature sensor is built into the MAF, so removing it will re...
Add to cart
3888Bosch LSU 4.9 5-wire, wide-band O2 sensor. Compatible with the LM-2, LC-2, and MTX-L, SCG-1, DLG-1, PSB-1, and PSN-1. NOTE: The latest generation widebands are compatible with both the Bosch LSU 4.2 and 4.9. Please note that the sensor connector...
Add to cart
Weatherpack style connector for GM boost control solenoid. This connector is pre-crimped with a 6" pigtail. Note: This connector is not needed for our newer style (12/2008 and newer) non-GM EBC Solenoid. We continue to offer these connectors for custom...
Add to cart
This tool makes de-pinning Weather Pack connectors a simple snap or poke. Just pop the seal retainer off, poke the tool in from the terminal side, slipping the tool over the terminal all the way in to release the latch, and pull the wire out from the...
Add to cart
Many older tachometers trigger off the negative terminal of the ignition coil. Often, these use a filtering circuit which will not trigger when given a 0 to 12 volt square wave signal, such as the tach output signal from an ECU or ignition box. If you h...
Add to cart
Reviews
There are no reviews yet.