$23.99
-
DB15 pigtail harness. Used for the extra I/O capabilities of the MSPNP Gen2 with V1.2 PCB (the version with the red main board).
You must be logged in to post a comment.
There are no questions yet, be the first to ask something for this product.
This electronic boost control solenoid can be used with the MS3-Pro/MSPNP2 or with other electronic boost controllers to control boost by adjusting the pressure to a turbo wastegate. The MS3-Pro, MS3-Pro Plug and Play, & MSPNP2 can drive this direct...
Add to cart
This FTDI chipset USB to Serial Adapter has been tested and works properly with all of our ECU products and all versions of TunerStudio on a wide range of operating systems. This is probably the most common item we see people come back for after a purch...
Add to cart
This tool makes de-pinning Weather Pack connectors a simple snap or poke. Just pop the seal retainer off, poke the tool in from the terminal side, slipping the tool over the terminal all the way in to release the latch, and pull the wire out from the...
Add to cart
Many older tachometers trigger off the negative terminal of the ignition coil. Often, these use a filtering circuit which will not trigger when given a 0 to 12 volt square wave signal, such as the tach output signal from an ECU or ignition box. If you h...
Add to cart
MegaSquirtPNP and DIYPNP IAT Sensor Kit - Steel Bung This is a simple kit to make it easier for you when removing your AFM/MAF when using a MegaSquirtPNP or DIYPNP. In many cases, the air temperature sensor is built into the MAF, so removing it will re...
Add to cart
TPS-3 Connector (Uncrimped) GM Style 3-pin TPS Connector complete with: the 3-pin connector three pins plus an extra fourth pin (just in case)
Add to cart
Reviews
There are no reviews yet.